WikiPedalia is not endorsed or affiliated with the Wikimedia Foundation.
The Sachs Elan 12-speed hub/Photos
Original article: https://www.sheldonbrown.com/sachs-elan/index.html on sheldonbrown.com
- Reproduced with the permission of John Allen and Harriet Fell — all rights reserved. The version on sheldonbrown.com is authoritative.
- Mirrored: 2026-10-11 · Last update of the original: see original
The Elan hub
This picture may not do justice to the size of the hub. The left flange is 105 mm in diameter, as large as on an old Sturmey-Archer Dynohub. The right flange is 132 mm in diameter. The sprocket was available in one size only -- 26 teeth. Still, the hub demanded a small chainwheel, typically 38 teeth, because of the large increase ratio to the top gear. The spoke holes are oversize, 2.6 mm, to make it easier to get spokes in the left flange past the right flange.
Identification
A view of the hub shell, showing the manufacturer's identification. The shell was of aluminum. How much this hub would have weighed with a steel shell is frightening to imagine.
Rotary shifter
The Elan had rotary shifting with the cable attachment inside the right dropout, a nice feature which has been used by Shimano and Sturmey-Archer as well.
Getriebe
The "Getriebe" or gear unit includes all of the Elan's gears. There are two stages of compound planetary gearing.
Note the very large diameter of the bearing retainer that is just inside the right side of the hub.This type of design is common to internal-gear hubs which do not have a thread-in right ball cup, and discourages use of oil lubrication because the oil would run out. The Elan goes one step further with grease lubrication: manufacturer's instructions are not to disassemble the Getriebe and so, not to clean and relubricate the internal parts. If there is a problem anywhere in the Getriebe, it must be replaced in its entirety! Perhaps one reason the gears are so massive is so they will need replacement less often.
Ratchet
Pawls at the inside of the sun gears engaged prongs which extend along the axle from the shifter assembly. Shimano Nexus 7 and 8-speed hubs use a similar arrangement, only pawls are blocked by a rotating sleeve around the axle. The Sachs prongs can rotate to three different positions, to engage a pawl in either direction or not engage it.
close-up
Here is a close-up view of the axle prongs.
Photos and captions by John S. Allen
unless otherwise indicated.


